FNIRSILCR-ST1 10KHz LCR Meter Tweezer, Mini Smart SMD Tester, ESR Meter, Multimeter, Capacitance Inductance Continuity Diode Tester, Auto Component Recognition Electronic Component Analyze

I needed milli-ohm testing capability for testing my motorcycle stator. Typical ohm-meters are not designed to measure well below 1.0 ohm but this one claimed to have this capability. I have been pleasantly surprised so far. I have compared readings with a set of precision 1% low ohm resistors and this thing is capable and accurate. Compared to what it would cost to have this capability in a Fluke or other name brand DVM's this is a major bargain. Would be nice if this included an adapter kit for banana jacks so I could use my clip leads. I will update this review after I've used this for other testing applications.

I purchased this to look for bad capacitors on an automotive circuit board. It worked perfectly to locate a bad capacitor that was visually OK. The meter is easy to use, I like the USB charging and battery life, and I would recommend this to anyone.

This is amazing. Learn so much about how everything works just walking these around. Indispensable! This is the multimeter to buy for a beginner. If you're just trying to troubleshoot, find a dead component, learn how the device works in the process. Not the most accurate/precise instrument but pretty dang accurate/precise for forty dollars. Battery life is okay. Display quality is still clear at the lowest brightness. Good contrast, display is crisp. Maxed by default but the chirp is minned. Instructions are in English and quite clear. Excellent device a little cheapish in the plastic department and we'll see about how long it lasts but right off the bat they seem more than sufficient for my intended use: troubleshooting dead boards.

Works great

Not laboratory grade but plenty accurate for my needs - and very convenient to use. Measures within the specified tolerance of components including capacitors, inductors, and 1% resistors, Closely agrees with another meter I have on capacitors plus it shows effective series resistance too. I was restoring some old tube equipment and this identified several caps that had gone bad in-circuit. This is designed to probe PWBs but I use it often with clip leads for point to point wiring and loose parts.

A must have when working with SMD, especially Capacitors and diodes.

EXCELENTE GRAN PRODUCTO....

I tested these tweezers with my certified calibration device and was pleasantly surprised how accurate the readings are. I would recommend these tweezers.