WuYan 220-240V 4W 4RPM Micro Synchronous Motor for Warm Air Blower 50Hz CW/CCW TYJ50-8A7 Microwave Oven Tray Motor

We have the Curries Essential model microwave. This motor replaces the original (made in China) motor.It has a similar specification and does the job perfectly

This is 25% of the price that some online spares retailers are selling it for but it's exactly the same part. Works perfectly in 1 year-old Bosch Innowave microwave.

Microwave turntable stopped turning so unable to heat items accurately and risk of overheating. Before getting rid and buying new I took the trouble to find out where the fault lay via utube and found that the little motor sits underneath the microwave in a little compartment which you can open with screws or, in my case with a Sainsburys microwave it was a bit more complicated as I had to cut through tiny metal webbing. The motor case was easy to remove and separate from electric wires. I then checked Amazon for a generic replacement and found this one which looked identical so took a chance and bought. Fitted perfectly, rejoined electric wires and pushed the metal casing back into place..took 5 minutes!. Works perfectly BUT REMEMBER TO REMOVE PLUG FROM SOCKET BEFIRE STARTING!,

My microwave turntable did not rotate, everything else ok. Easy to fit and for a cheap fix.

Works perfectly. My Kenwood microwave gave up spinning the glass plate so I thought I’d open her up and see if I could mend it. I wasn’t sure if this would work as there were no markings on the original but the shame was the same. Worked a treat.

Please with product.

Arrived within a day of ordering. Fitted to an aging Dimplex coal effect fire having failed to aquire a direct part from dimplex or on-line spares. Although the dimensions of the motor are 50mm dia (40mm for the original) it fitted directly to the alternative predrilled holes with the connecting sleeve enlarged by just 0.5mm. I had to provide x2 wires to connect on my fire but the installation took only 15mins, access to the motor and electrics took longer but was a good opportunity to hoover all the fluff etc that builds up over the years! Would recommend.

Would have given 5 stars. But as the pictures tell the shaft from the motor to the turntable coupling was too small. So I took the risk of changing the cog from the old to the new motor.Note the failure of the old one, 2 shiny bits on coil, (burnt out coil). Caused by heat, metal fatigue, mains surge? Not sure.SHOULD HAVE CHECKED SIZE OF SHAFT BEFORE BUYING. 🙄Got a microwave leak tester in case.Tested motor before fitting.Job done, no leaks. Table turns.