Creativity Full Assembled Ender 3 Hotend Upgraded Kit with Nozzles 3D Printer Parts Accessories Replacement for Ender 3s/ Ender 3 Pro 3D Printer

Super easy install. Just took off a few screws, and plugged in everything on the new extruder right where the only ones went. Intuitive, and immediately printed great on the first try. For the cost, it works great, and is cheaper than other assemblies. Looks and holds up just like the original.

Great value easy install

Easy to install, works great.

So it didn’t come with instructions so we had slowly assumed where wires went. One wire had a connector but we had to cut it off for a direct wire insert.Once connected it works great. Slight upgrade from original. Because of the lack of a manual and having to cut off a connector…it gets 4

Great upgrade! Yellow and blue wire are for the fan, just in case. No instructions which would have been nice, but we figured it out.

Works great, watch your wiring. The quality is first rate and is just want I needed for my ender 3, a great price as well. I suggest that you take photos of your original wiring with your cell phone before disassembly as there is what appears to be an extra wire on the new Hotend that will be confusing as to where things go on the new one. Take photos of the wiring on the old Hotend and where they connect on the circuit board. I followed what was an extra wire on the new Hotend and compared it to my old one and plugged it in the location I thought it belonged in. If you pay attention and look at your photos as I suggest its obvious to figure it out. Overall though a great replacement.

this is a direct replacement for the original printing head. The mount to the X axis traveler if altered with another 3D printed part fore a different printing head will cause a crash condition.

Overall easy set up. I did end up breaking my fan .. again.. and had to order a new one but overall, the new hot end has done well, and the additional nozzles were a nice bonus.